This flat-based Hamilton, or 'torpedo' bottle stands 240 mm high, with a 64-mm wide base and is approximately 90 mm wide at the waist. It has a 'bottle logo' embossed on its base. There are possibly other text/numerals that have since worn away. The bottle shows moulding scars on the base and sides. It has a crown top finish. The egg-shaped bottle was first patented by William Francis Hamilton in 1814, the idea being that the bottle had to be stored on its side to keep the cork wet and ensuring a good seal on the reusable bottle. In around 1870, the flat based egg or Hamilton bottle was introduced. Following the 'blob top' finish being replaced by the crown top and cork sometime after 1892, when this cap design was patented, the design became more popular. This was because the bottles could now be reliably stored upright without cork shrinkage and a leaky seal causing loss of the carbonated gas. This is recognisable on this bottle by the beaded rim that the metal cap fitted over. These are also generally c.25mm in diameter. The cap would have been metal with a cork lining. This, however, lead to the decline in the popularity of torpedo bottles as it made them no longer necessary (Lucas, 2010). The mould scar travels up the neck to the lip of the bottle and this would suggest that it was manufactured around 1910 on a semi or fully automated bottle making machine, near to the end of their popularity. The 'bottle logo' on the base is probably the manufactures logo, however, several manufacturers used the same logo as their mark and therefore it has not now been possible to isolate its exact point of manufacture. The bottles were extensively exported from the U.K. and are therefore found around the world, but particularly in the former colonies and North America. This flat-based Hamilton, or 'torpedo' bottle stands 240 mm high, with a 64-mm wide base and is approximately 90 mm wide at the waist. It has a 'bottle logo' embossed on its base. There are possibly other text/numerals that have since worn away. The bottle shows moulding scars on the base and sides. It has a crown top finish. The egg-shaped bottle was first patented by William Francis Hamilton in 1814, the idea being that the bottle had to be stored on its side to keep the cork wet and ensuring a good seal on the reusable bottle. In around 1870, the flat based egg or Hamilton bottle was introduced. Following the 'blob top' finish being replaced by the crown top and cork sometime after 1892, when this cap design was patented, the design became more popular. This was because the bottles could now be reliably stored upright without cork shrinkage and a leaky seal causing loss of the carbonated gas. This is recognisable on this bottle by the beaded rim that the metal cap fitted over. These are also generally c.25mm in diameter. The cap would have been metal with a cork lining. This, however, lead to the decline in the popularity of torpedo bottles as it made them no longer necessary (Lucas, 2010). The mould scar travels up the neck to the lip of the bottle and this would suggest that it was manufactured around 1910 on a semi or fully automated bottle making machine, near to the end of their popularity. The 'bottle logo' on the base is probably the manufactures logo, however, several manufacturers used the same logo as their mark and therefore it has not now been possible to isolate its exact point of manufacture. The bottles were extensively exported from the U.K. and are therefore found around the world, but particularly in the former colonies and North America. A RDF representation of MAS-F100103 2017-08-23T08:15:00+01:00 2018-05-23T14:00:10+01:00 MAS-F100103 MAS-F100103 GB en-GB The Trustees of the British Museum The Trustees of the British Museum 1 The period from for the object http://purl.org/NET/Claros/vocab#Thumbnail Attribute as courtesy of the British Museum A thumbnail image of MAS-F100103 With finder Glass Primary material of object Complete 90. Diameter 90. Height By Attribution 3.0 Attribute as courtesy of the British Museum A full resolution image of MAS-F100103 Method of manufacture Classification of object